Hi I'm new so go easyðŸ˜‚ðŸ˜‚
OK ok where do I start.
Glad I found this forum that's for sure.
Loosing the will to live here.
Right now I want edge start.
Yes I'm trying to punch a centre no idea how I mark a point so made a 1mm circle.
That no good.
Now I have 2 start points.
The hole is inside so he s1 I can move that anywhere and see the lead In
Now the outside I can't see the lead in no matter how big I put it and the s2 for outside I can not move it.
S2 is way over other side.
Not where I want it.
Trying to cut 30mm plate.
I'm going to mill the hole but would like a pierce punch hole but failing at both.
Can anyone point me in right direction as feeling dumb here.
If you have any problems accessing the forum or email then ask here.
1 post • Page 1 of 1