Start point ?

If you have any problems accessing the forum or email then ask here.
Post Reply
plasmabob

Start point ?

Post by plasmabob » Wed Sep 08, 2010 8:16 pm

:D Hey all looking for some help with my sheet cam ...I updated to ver3. from 2.11 I think anyway my start point seems to wan't to be the middle of the sheet not down in the corner where I tell it to be .... Anyone know how to fix this ? :x I am using autocad, mp300.mach 3 on plasma table... I am fairly green on all this ..




Thanks,Plasmabob

riya

Post by riya » Tue Jul 30, 2013 10:36 am

Sure hope someone is there to provide some feedback!





learn-language http://http://www.learn-language.me
Testking OG0-093 Testking OG0-093
Testking rhce Testking rhce
Testking vmware certification Testking vmware certification

Post Reply