V4.1.19 released

New releases and important announcements will be posted here. This is for announcements only. Please use the new features or problems forums to discuss new releases.
Post Reply
User avatar
Les Newell
Site Admin
Posts: 3661
Joined: Thu May 11, 2006 8:12 pm

V4.1.19 released

Post by Les Newell »

Hi all,

I have just uploaded V4.1.19 to www.sheetcam.com. This version has the following changes:

Fixed: Offsetting a line consisting of one segement not working
Fixed: 'Reverse open paths' not working when open paths are offset
Fixed: Open paths sometimes starting in the middle rather than one end.
Fixed: 'climb cut' not working for open paths
Fixed: Drawing remaining highlighted when it shouldn't be
Removed: 'Fixed' attribute for start points. Start points are now always fixed
Added: Better automatic optimisation
Fixed: Occasional incorrect part limits if part contains open paths
Fixed: Can now select parts in nesting mode even if they are only open paths
Added: scLoadTools and scSaveTools to plugin API

Les
Post Reply