V4.1.14 released

New releases and important announcements will be posted here. This is for announcements only. Please use the new features or problems forums to discuss new releases.
Post Reply
User avatar
Les Newell
Site Admin
Posts: 3660
Joined: Thu May 11, 2006 8:12 pm

V4.1.14 released

Post by Les Newell »

Hi all,

I have just uploaded V4.1.14 to www.sheetcam.com. This version has the folllowing changes:

Changed: drillstart post event changed to drillbegin
Added: Plasma loop size option
Added: Plasma loop collision detection. In most cases, if a loop will gouge it is deleted.
Added: Offsetting open contours. These are always offset to the right of the start point. To reverse the cut side, move the start point.

Note that offsetting open contours is very experimental so expect the unexpected ;-)
***WARNING*** If your job relies on open paths not being offset then this version WILL break it. Check before cutting!
Post Reply