J Leadin For holes
Posted: Mon May 24, 2021 7:59 am
Les is it possible to do a J shaped leadin on holes?
Eg. pierce at the hole centre, then move to the start of the arc leadin shown in the pic. then carry on as normal This would leave the pile of dross on a pierce as far from the cut as possible but provide a nice leadin more like the Hypertherm true hole technology.
I want to combine it with an overcut which can be done in Plasmac without the postprocessor getting involved.
Eg. pierce at the hole centre, then move to the start of the arc leadin shown in the pic. then carry on as normal This would leave the pile of dross on a pierce as far from the cut as possible but provide a nice leadin more like the Hypertherm true hole technology.
I want to combine it with an overcut which can be done in Plasmac without the postprocessor getting involved.