Page 1 of 1

Disable "loop corners" individually

Posted: Sun Mar 29, 2020 7:07 am
by mancavedweller
Just like we can change the properties of leadins/leadouts individually, it would be good if the same could happen with looping on corners.

Had a situation today where a couple of corners were too close to an edge and so had to disable all loops to get round this.

Re: Disable "loop corners" individually

Posted: Wed Sep 23, 2020 2:17 pm
by gilley76
I'm going to attempt to loop certain parts of my drawing. I figured I would just have to select them and create a different layer for them if that's possible. I don't know if that helps you any.