Disable "loop corners" individually

Request and discuss new features
Post Reply
mancavedweller
Posts: 161
Joined: Tue Feb 25, 2014 6:53 am

Disable "loop corners" individually

Post by mancavedweller »

Just like we can change the properties of leadins/leadouts individually, it would be good if the same could happen with looping on corners.

Had a situation today where a couple of corners were too close to an edge and so had to disable all loops to get round this.
gilley76
Posts: 1
Joined: Thu Aug 23, 2018 7:12 pm

Re: Disable "loop corners" individually

Post by gilley76 »

I'm going to attempt to loop certain parts of my drawing. I figured I would just have to select them and create a different layer for them if that's possible. I don't know if that helps you any.
Post Reply