Page 1 of 1

Tool additions

Posted: Wed May 23, 2018 9:42 am
by Davek0974
Is there a way we can have Overburn and path rules tied to each tool so when i change tool it also brings in the overturn and path rule settings?


Thanks

Re: Tool additions

Posted: Wed May 23, 2018 11:28 am
by Les Newell
Currently there isn't any way to do this. May be able to add this if there is enough interest.

Re: Tool additions

Posted: Wed May 23, 2018 4:49 pm
by djreiswig
And lead in and lead out settings, too. Since they usually change with the material being cut.

Re: Tool additions

Posted: Wed May 23, 2018 7:40 pm
by SeanP
One way I have been trying recently is saving a separate toolset for each material, doing that then saves each set of path rules for the material.
It's not a bad method and fairly quick to load up, don't really use overburn to be honest.

Re: Tool additions

Posted: Sun Aug 18, 2019 5:55 pm
by Davek0974
Any updates on this Les?

Still impossible?

:P

Re: Tool additions

Posted: Mon Aug 19, 2019 3:58 pm
by Les Newell
Not many people expressed an interest so it's pretty low on the to-do list I'm afraid.

Re: Tool additions

Posted: Mon Aug 19, 2019 6:51 pm
by luis lopez
I would be very grateful to add that option

Re: Tool additions

Posted: Mon Aug 19, 2019 8:46 pm
by Davek0974
Les Newell wrote: Mon Aug 19, 2019 3:58 pm Not many people expressed an interest so it's pretty low on the to-do list I'm afraid.
Fair enough, i'll keep my fingers crossed ;)