Tool additions

Request and discuss new features
Post Reply
Davek0974
Posts: 279
Joined: Sat Feb 01, 2014 2:07 pm

Tool additions

Post by Davek0974 » Wed May 23, 2018 9:42 am

Is there a way we can have Overburn and path rules tied to each tool so when i change tool it also brings in the overturn and path rule settings?


Thanks

User avatar
Les Newell
Site Admin
Posts: 2280
Joined: Thu May 11, 2006 8:12 pm

Re: Tool additions

Post by Les Newell » Wed May 23, 2018 11:28 am

Currently there isn't any way to do this. May be able to add this if there is enough interest.

djreiswig
Posts: 127
Joined: Sat Feb 20, 2016 4:47 am

Re: Tool additions

Post by djreiswig » Wed May 23, 2018 4:49 pm

And lead in and lead out settings, too. Since they usually change with the material being cut.

SeanP
Posts: 107
Joined: Wed Oct 23, 2013 9:50 am

Re: Tool additions

Post by SeanP » Wed May 23, 2018 7:40 pm

One way I have been trying recently is saving a separate toolset for each material, doing that then saves each set of path rules for the material.
It's not a bad method and fairly quick to load up, don't really use overburn to be honest.

Davek0974
Posts: 279
Joined: Sat Feb 01, 2014 2:07 pm

Re: Tool additions

Post by Davek0974 » Sun Aug 18, 2019 5:55 pm

Any updates on this Les?

Still impossible?

:P

User avatar
Les Newell
Site Admin
Posts: 2280
Joined: Thu May 11, 2006 8:12 pm

Re: Tool additions

Post by Les Newell » Mon Aug 19, 2019 3:58 pm

Not many people expressed an interest so it's pretty low on the to-do list I'm afraid.

luis lopez
Posts: 25
Joined: Sun Nov 24, 2013 12:44 am

Re: Tool additions

Post by luis lopez » Mon Aug 19, 2019 6:51 pm

I would be very grateful to add that option

Davek0974
Posts: 279
Joined: Sat Feb 01, 2014 2:07 pm

Re: Tool additions

Post by Davek0974 » Mon Aug 19, 2019 8:46 pm

Les Newell wrote:
Mon Aug 19, 2019 3:58 pm
Not many people expressed an interest so it's pretty low on the to-do list I'm afraid.
Fair enough, i'll keep my fingers crossed ;)

Post Reply