Color in function of the area

Request and discuss new features
Post Reply
Andreas
Posts: 23
Joined: Wed Jan 25, 2017 10:15 pm

Color in function of the area

Post by Andreas »

Another feature that if there is not already, and that I would return to profit, would be to be able to function in a color automatically assigned to a certain area of ​​the drawing, such as passing a programmable surface value the program checks the yellow below that value blue. Already exists this function?
User avatar
Les Newell
Site Admin
Posts: 3661
Joined: Thu May 11, 2006 8:12 pm

Post by Les Newell »

In SheetCam colours indicate the type of contour. Red is outside, yellow is inside and grey is open. You cannot set the colours from your drawing.
Andreas
Posts: 23
Joined: Wed Jan 25, 2017 10:15 pm

Post by Andreas »

I'll explain but google translator does not help me ... when I make a check design to large areas of one color and areas small (holes) another color, in this way, with two tools at different speeds, I make sure that the work to be done at speed from the table Hypertherm large areas and reduced by 40% on small areas. I tried it and it works, wondering if it was possible to implement an automatic function that in complex designs by assigning a minimum area value the program gives the DXF automatically two colors.
Post Reply