Sequential mouse click ordering of Start Points
Posted: Fri Jan 15, 2016 10:09 pm
Hi Les,
I can't beleive I haven't suggested this earlier.
Lots of times I've re-arranged the pierce point positions and order. Positions is easy because you can just click at the position you want.
However, the order of start points is not as easy. I have to right click on the start point, select properties, then type in the order in the dialog box. Very time consuming when I have a lot of this to do.
Would it be possible to add some extra functionality to the start point mouse clicking. For instance a button "Start Sequential Pierce Point Order" is clicked on. A box then pops up asking what number this Start Point is. Let's say it's 10 so we type that in and press enter. Now every mouse click not only positions the start point but automatically increments from 10. This would give a massive reduction in time for such an operation.
Of course the user would have to be careful he doesn't select one of the start point from 1-10 because in this case the ordering was started after Start Point 10.
To stop sequential start point ordering you just click again on "Start Sequential Pierce Point Order" or go to a different mode (Edit Contours, etc).
Keith.
I can't beleive I haven't suggested this earlier.
Lots of times I've re-arranged the pierce point positions and order. Positions is easy because you can just click at the position you want.
However, the order of start points is not as easy. I have to right click on the start point, select properties, then type in the order in the dialog box. Very time consuming when I have a lot of this to do.
Would it be possible to add some extra functionality to the start point mouse clicking. For instance a button "Start Sequential Pierce Point Order" is clicked on. A box then pops up asking what number this Start Point is. Let's say it's 10 so we type that in and press enter. Now every mouse click not only positions the start point but automatically increments from 10. This would give a massive reduction in time for such an operation.
Of course the user would have to be careful he doesn't select one of the start point from 1-10 because in this case the ordering was started after Start Point 10.
To stop sequential start point ordering you just click again on "Start Sequential Pierce Point Order" or go to a different mode (Edit Contours, etc).
Keith.