Lead in / lead out for open profiles

Request and discuss new features
Post Reply
Curmudgeon

Lead in / lead out for open profiles

Post by Curmudgeon »

I see where back in 2007 it was on the short list, but in the demo/eval copy I downloaded a few days ago, it still was not an option. I know there are some who think evey senario where this would be usefull can be resolved by simply leangthening the lines, but I don't want to loose the exact geometry, and it's built from a more complicated drawing that I also don't want to change. Is this likely to be supported in the near future ?
It's a show stopper for me since I haven't yet purchased the CAD software I plan to use.




-------------------- m2f --------------------

Reply to this post simply by hitting reply in your email client or you can read this topic online here:
http://www.forum.sheetcam.com/viewtopic ... 0950#10950

-------------------- m2f --------------------
User avatar
Les Newell
Site Admin
Posts: 3661
Joined: Thu May 11, 2006 8:12 pm

Lead in / lead out for open profiles

Post by Les Newell »

The most difficult bit is making sure that the leadins end up on the right side of the contour. I'll have a nother look at the code.




-------------------- m2f --------------------

Reply to this post simply by hitting reply in your email client or you can read this topic online here:
http://www.forum.sheetcam.com/viewtopic ... 0952#10952

-------------------- m2f --------------------
Curmudgeon

Lead in / lead out for open profiles

Post by Curmudgeon »

Thanks !
Hopefuly it's doable without a lot of effort.




-------------------- m2f --------------------

Reply to this post simply by hitting reply in your email client or you can read this topic online here:
http://www.forum.sheetcam.com/viewtopic ... 0953#10953

-------------------- m2f --------------------
Post Reply