New Wish List item

Request and discuss new features
Post Reply
jono

New Wish List item

Post by jono »

How about putting the Ramp in the tab. so the Point to ramp up is the Stratpoint of the tab.
An other solution could be, to put two tabs at the same middlepoint. the inner one with the normal endpoints of the tab and the other one tablength and both ramps. So you should get the start point of the Ramp.





------------------------
www.woodcnc.de





------------------------
www.woodcnc.de





------------------------
www.woodcnc.de





------------------------
www.woodcnc.de




-------------------- m2f --------------------

Reply to this post simply by hitting reply in your email client or you can read this topic online here:
http://www.forum.sheetcam.com/viewtopic ... 0839#10839

-------------------- m2f --------------------
Post Reply