Rapid positing with burny 5?

General chat and non SheetCam related discussion
Post Reply
jason_alex

Rapid positing with burny 5?

Post by jason_alex » Thu Feb 13, 2014 9:46 pm

Hey guys I am new to sheet cam I have to say I am a big fan, I am running a burny 5 controller using sheet cam to export my drawlings. I was wondering what I am doing wrong when my machine move position instead of running rapid movement it runs at normal run speed.

My question, is any one running sheet cam with burny 3 or 5 and using the rapid positing?

Can sheet cam control speed in a burn 3 or 5 application?

Post Reply