Page 1 of 1

Rapid clearence plane

Posted: Mon Jan 13, 2014 8:24 pm
by jrfab
having trouble with this when im loading a dxf and it says start cut is above rapid clearance plane how do I change this

Posted: Tue Jan 14, 2014 1:26 pm
by Les Newell
having trouble with this when im loading a dxf and it says start cut is above rapid clearance plane how do I change this
Your pierce height (in the tool definition) is higher than the rapid clearance (in Options->job options->material). This can cause some issues with piercing.