Rapid clearence plane

General chat and non SheetCam related discussion
Post Reply
jrfab

Rapid clearence plane

Post by jrfab » Mon Jan 13, 2014 8:24 pm

having trouble with this when im loading a dxf and it says start cut is above rapid clearance plane how do I change this

User avatar
Les Newell
Site Admin
Posts: 2575
Joined: Thu May 11, 2006 8:12 pm

Post by Les Newell » Tue Jan 14, 2014 1:26 pm

having trouble with this when im loading a dxf and it says start cut is above rapid clearance plane how do I change this
Your pierce height (in the tool definition) is higher than the rapid clearance (in Options->job options->material). This can cause some issues with piercing.

Post Reply