Post-processor for Haas GR-510

Having problems with or questions about SheetCam? Post them here.
Post Reply
CBredel
Posts: 1
Joined: Mon Jun 28, 2021 8:51 pm

Post-processor for Haas GR-510

Post by CBredel »

I am purchasing a Haas GR-510 router for work and I am trying to find a post processor for SheetCam to send g-code to it. If it can't be done through SheetCam, I know I can just use the Haas interface, but I think Sheetcam will be easier for 1-off parts.

I did see there are 3 Haas posts loaded already, but I don't know if any of those will work.

I won't have the machine for a couple months so I'm trying to make sure I can be as prepped as possible so I can run it as soon as it's ready to run.
Post Reply