Nesting

Having problems with or questions about SheetCam? Post them here.
Post Reply
likes
Posts: 1
Joined: Fri May 28, 2021 7:15 pm

Nesting

Post by likes »

Just updated to the latest version of Sheetcam,7.0.13. Been using sheetcam for about 3 years now for plasma cutting.

When i nest parts inside other parts to utilize all my material and minimize scrap, i have to manually optimize nesting, no big deal. I used to click manual optimization (keep parts together). When i would scroll down the list of parts it would highlight the part selected on the job so i can visually see what part was cut next. It doesn't do that anymore. It would be nice if it did that again so i can properly nest my parts.

Other than that i like the current version. It does have some quirks and bugs. sometimes it will show "phantom" parts or layers when im going from part to part editing contours and generating tool paths.

thank you for any and all help!
Post Reply