G Code not loading to Mach 3 Properly
-
- Posts: 2
- Joined: Fri Apr 30, 2021 4:09 pm
G Code not loading to Mach 3 Properly
I can download art and import the dxf file to sheetcam and create job files fine. When I run the post processor the tap file created is not complete. When I open the g code in Mach 3 it is only producing a few lines of code. Please help. I have attached the dxf, job and tap file for you to see. I should also note that previously downloaded and converted files open fine in Mach 3. This issue just started and I need help!
- Attachments
-
- 3Gnomes with Hearts.tap
- (208 Bytes) Downloaded 106 times
-
- 3Gnomes with Hearts.job
- (97.36 KiB) Downloaded 107 times
-
- 3Gnomes with Hearts.dxf
- (412.72 KiB) Downloaded 99 times