G Code not loading to Mach 3 Properly

Having problems with or questions about SheetCam? Post them here.
Post Reply
Capemonroe
Posts: 2
Joined: Fri Apr 30, 2021 4:09 pm

G Code not loading to Mach 3 Properly

Post by Capemonroe » Tue May 04, 2021 10:39 pm

I can download art and import the dxf file to sheetcam and create job files fine. When I run the post processor the tap file created is not complete. When I open the g code in Mach 3 it is only producing a few lines of code. Please help. I have attached the dxf, job and tap file for you to see. I should also note that previously downloaded and converted files open fine in Mach 3. This issue just started and I need help!
Attachments
3Gnomes with Hearts.tap
(208 Bytes) Downloaded 9 times
3Gnomes with Hearts.job
(97.36 KiB) Downloaded 8 times
3Gnomes with Hearts.dxf
(412.72 KiB) Downloaded 9 times

Post Reply