Les
scanything for Linux (didn't know it worked on Linux)
what would I need to do to get it working on master (2.9?)
is there an idiots guide?
I've installed linuxcnc from iso and update from buildbot as I am using QtPlasmaC
thanks as always
Rob
scanything: Linux?
- Les Newell
- Site Admin
- Posts: 3667
- Joined: Thu May 11, 2006 8:12 pm
Re: scanything: Linux?
As long as you have halcompile installed, Scanything should work. Basically it builds a driver to match your setup on-the-fly.
-
- Posts: 257
- Joined: Thu Feb 26, 2015 12:11 am
Re: scanything: Linux?
thanks les, I'll give it a go (I'll get the camera the right way round this time )