Offsetting Open Paths for Rotary

[cloudy]

I'm trying to generate tube cuts for the Rotary plugin. I input flattened CAD, with the horizontal paths removed (So sheetcam doesn't generate a lengthwise cut)

This means the path is open. I've enabled offset open paths - but no matter which side I choose the cut is on the inner (wrong) side (and indeed the leadins are inside the intended part... Any ideas?

tube.PNG (15.44 KiB) Viewed 720 times

[djreiswig]

Move the start points to the other end of the lines. It should switch the cut side.

[cloudy]

That was it! Thankyou

[djreiswig]

Been there, done that. Glad it worked for you.