Adding tabs to open paths

Having problems with or questions about SheetCam? Post them here.
Post Reply
lumberjack_jeff
Posts: 9
Joined: Sat Feb 29, 2020 4:10 am

Adding tabs to open paths

Post by lumberjack_jeff »

Hi Les,
I get a "some toolpaths were not generated correctly - please report this as a bug" when adding tabs to open paths.

I have only experienced this with release 6.9.17

Thanks
Attachments
Support.zip
(27.69 KiB) Downloaded 42 times
User avatar
Les Newell
Site Admin
Posts: 3661
Joined: Thu May 11, 2006 8:12 pm

Re: Adding tabs to open paths

Post by Les Newell »

There is very little room for the ramps and it is getting stuck trying to fit the ramps in. If you run simulation on that cut you'll see what I mean.
I'll try to fix it for the next release.
Post Reply