Hi
Can anyone help? I recently had a hard disc failure and have had to replace it, after doing that
I have reinstalled all my programs without any problems except Sheetcam.
When I run the newly downloaded program I find that there are no Post Processors listed.
My question is how can I load the Post Processors to enable the program to work?
Any help would be appreciated.
Best regards
Roy
No Post Processers
Re: No Post Processers
On my system (Linux), the post processors are kept in c:/sheetcam/posts. You might check your system and see if it's the same on yours.
Steve
Steve
Re: No Post Processers
Hi Steve
Many thanks for your help I have now found them and they are in the sub directory you advise.
I am learning something new every day.
Regards
Roy
Many thanks for your help I have now found them and they are in the sub directory you advise.
I am learning something new every day.
Regards
Roy