Start and end of cut path doesn't meet up.

Having problems with or questions about SheetCam? Post them here.
Post Reply
Kpbbl
Posts: 1
Joined: Sun Dec 20, 2020 5:55 pm

Start and end of cut path doesn't meet up.

Post by Kpbbl »

I am trying to cut some letters and I can't seem to get the start and end points to meet. The gantry appears to begin its movement before the torch has fully descended and ignited. 

I have tried adjusting lots of settings but have had no luck. I have attached a photo of what the cuts look like - you see both the inner and outer cuts are incomplete. 

Any suggestions would be appreciated. I'm a complete beginner so may ask some silly questions.

Thanks

Kate
Attachments
20201220_181254.jpg
20201220_181254.jpg (889.01 KiB) Viewed 4943 times
Post Reply