I've got two learning curves
SheetCam is really a relearn. Its been over 10 years since SheetCam was a daily tool.
I was not seeing SC do what I thought I remembered I uninstalled, did a deep cleanse, shut down and rebooted computer, reinstalled SC. Things worked better. But after a bunch of attempts with a couple of simple designs I tried just creating a cirle, exported to a dxf, imported into SC.
Question: after creating an operation and running the baileigh post processor, three icons are grayed out: Segment ends, Path ends, start points.
any ideas why these would be missing?
thanks
Dick D
SC icon problems-where to start
Re: SC icon problems-where to start
Are you maybe in nesting mode? I know some of the functions are disabled in certain modes.