hi
back in 2008-2011 i had a dynatorch and i was using sheetcam to process all my files (dxf, svg, etc.)
now i am trying to get back on the bicycle. i installed the baileigh starfire post processor, brought my dxf in to sheetcam, ran the post processor but all i am getting is
G92 X0 Y0
G40
G90
M02
what am i missing.
the dwf file is 45,306 lines.
(1st 15 lines)
0
SECTION
2
HEADER
9
$ACADVER
1
AC1021
9
$ACADMAINTVER
70
25
9
$DWGCODEPAGE
3
...........................
(last 7 lines)
RTVSPropertyOp27
70
1
0
ENDSEC
0
EOF
thanks in advance
baileigh starfire post no working???
Re: baileigh starfire post no working???
Did you create an operation?
Re: baileigh starfire post no working???
I stepped again thru the entering setup part. Created the operation. But I am missing something. See my last post re: missing elements.
Thanks for ur suggestion. I will keep digging.
Thanks for ur suggestion. I will keep digging.
Re: baileigh starfire post no working???
Usually when you don't get any moves in the code it's because you don't have an operation. There are no paths to output. If you have a valid operation, then I'm not sure why your post processor isn't outputting code.