Delay before piercedelay Mach3 THC with scriber.scpost

Having problems with or questions about SheetCam? Post them here.
Post Reply
Donbug
Posts: 2
Joined: Sun Jun 21, 2020 9:58 am

Delay before piercedelay Mach3 THC with scriber.scpost

Post by Donbug » Thu Dec 10, 2020 6:52 pm

Hi, i have a thing i want to change if possible.
I use Mach3 THC with scriber.scpost, and when my torch goes down to touch the plate i waits for about 3-4 seconds before it goes up again to the pierceheight, is that something i can change ?

Post Reply