Page 1 of 1

Post processor advice

Posted: Wed Nov 11, 2020 2:35 pm
by Roc
Running a Messer plasma machine that's approximately 15 years old. I primarily run 200 and 260 amp torches. All torches are hypertherm xd. I believe the nesting software is Omniflow but cannot seem to find the name anywhere. Only that it is Global Control? I am trying to figure out the correct (or best for that matter) post processor setup.
20201111_091849.jpg
20201111_091849.jpg (595.98 KiB) Viewed 4828 times