Post processor advice

Having problems with or questions about SheetCam? Post them here.
Post Reply
Roc
Posts: 3
Joined: Tue Nov 03, 2020 10:34 pm

Post processor advice

Post by Roc » Wed Nov 11, 2020 2:35 pm

Running a Messer plasma machine that's approximately 15 years old. I primarily run 200 and 260 amp torches. All torches are hypertherm xd. I believe the nesting software is Omniflow but cannot seem to find the name anywhere. Only that it is Global Control? I am trying to figure out the correct (or best for that matter) post processor setup.
20201111_091849.jpg
20201111_091849.jpg (595.98 KiB) Viewed 1216 times

Post Reply