Sheetcam
-
- Posts: 1
- Joined: Sun Aug 16, 2020 3:07 am
Sheetcam
I currently use a Hypertherm controller on our CNC Plasma cutting table is this suitable to transfer the G-Codes from Sheetcam as I notice that on the Internet Mach 3 and 4 are constantly mentioned.
- Les Newell
- Site Admin
- Posts: 3665
- Joined: Thu May 11, 2006 8:12 pm
Re: Sheetcam
Yes, SheetCam should work with your hypertherm controller. In SheetCam go to Options->machine->post processor and select the Hypertherm post processor that most closely matches your machine.