Page 1 of 1

Selecting the correct post processor

Posted: Wed Jul 22, 2020 10:40 am
by plasmacut85
Hello,

I am looking for advice on which post processor I should be selecting under the tabs, machine>post processor. I am running an STV CNC Plasma table that uses My Plasm CNC. More info on the controller can be found here https://www.proma-elektronika.com/myplasm-cnc-system/

Thanks in advance!

Re: Selecting the correct post processor

Posted: Mon Feb 27, 2023 5:32 pm
by rrossetti
on the dropdown list choose mach3 no z