Post Processor problem

Having problems with or questions about SheetCam? Post them here.
Post Reply
Roy Smart
Posts: 19
Joined: Fri Apr 19, 2019 11:43 am

Post Processor problem

Post by Roy Smart » Sat Jul 04, 2020 2:46 pm

Hi All
I am having problems with Mach 3 post processor.
The Z axis will not change above 0.5000 although the rapid movement
is set to 10mm. Can anyone help with this problem? I am using the Mach 3
processor on sheetcam.
Many thanks for any help or advice.
Regards
Roy

Post Reply