Stepping on straight cuts

Having problems with or questions about SheetCam? Post them here.
Post Reply
ATPPF
Posts: 1
Joined: Wed May 27, 2020 8:46 pm

Stepping on straight cuts

Post by ATPPF » Wed May 27, 2020 9:02 pm

Looking for help on what could be causing this.... 
Set up is plasma route table
Victor plasma cutter 
Using sheetcam and mach 3
Problem used to be minor and now seems to be getting worse and more frequent. Have tested with torch off, still does the same thing. Have also checked all gears and rollers, everything appears to be good and tight. I also know it isn't stray nodes as it does this same thing with every file.
Attachments
20200527_150129.jpg
20200527_150129.jpg (1.42 MiB) Viewed 2173 times
20200527_145956.jpg
20200527_145956.jpg (1.88 MiB) Viewed 2173 times

Post Reply