Suddenly G03

Having problems with or questions about SheetCam? Post them here.
Post Reply
tas99
Posts: 8
Joined: Sat Mar 28, 2020 4:48 pm

Suddenly G03

Post by tas99 » Wed May 06, 2020 3:06 pm

All of my earlier cuts have square corners but suddenly all my corners have a G03 command and cut in arc moves.

Have I inadvertently enabled a function I'm not aware of? In the "Operations" I see there is something called
Loop Sharp Corners but it is set to 0 and None is checked below it.

Any ideas?

Tom

Post Reply