Is there a way to stop the retract to safe height between successive passes of a pocket. After each pass of a pocket the tool retracts to a safe height then returns to the material for the next pass around the pocket.
I'd like for it to just continue milling the pocket deeper as it goes. Perhaps I have missed something or under some conditions where it acts differently.
Retract during Pocket
- Les Newell
- Site Admin
- Posts: 3661
- Joined: Thu May 11, 2006 8:12 pm
Re: Retract during Pocket
With pocketing it will lift to safe Z. The problem is that for pockets with islands it could need to rapid over those islands.