Negative lead out

Having problems with or questions about SheetCam? Post them here.
Post Reply
ZX-Sinclair
Posts: 16
Joined: Thu Oct 22, 2015 10:33 am

Negative lead out

Post by ZX-Sinclair »

Hello,
after an update, it's not possible to enter a negative "lead out" to prevent the plasma torch to cut same place twice.
In former times it was possible to insert " - 1,2 " mm. Now the smallest value is " 0 ".
What can i do?
ZX-Sinclair
Posts: 16
Joined: Thu Oct 22, 2015 10:33 am

Re: Negative lead out

Post by ZX-Sinclair »

Is there NO solution?
User avatar
Les Newell
Site Admin
Posts: 3660
Joined: Thu May 11, 2006 8:12 pm

Re: Negative lead out

Post by Les Newell »

Do you mean a negative overcut? A negative lead out doesn't really make sense and I don't think SheetCam has ever allowed that.
ZX-Sinclair
Posts: 16
Joined: Thu Oct 22, 2015 10:33 am

Re: Negative lead out

Post by ZX-Sinclair »

You are right!
After an installation on a new PC in German, i switched back to english. Then it's better to understand.
Post Reply