Nesting / Tool Path

Having problems with or questions about SheetCam? Post them here.
Post Reply
Pussnboobs
Posts: 9
Joined: Sat Feb 01, 2020 11:44 am

Nesting / Tool Path

Post by Pussnboobs »

Hi Guys this may have been covered before but I can't find it in the search engine. I was wondering if I toolpath individual items can I then bring them together already tool pathed. I do a lot of repeditive parts but not enough to fill one sheet each time so I was hoping to be able to use a previous tool pathed item to save having to re path each time I use it in a different nest.
Thanks
User avatar
Les Newell
Site Admin
Posts: 3661
Joined: Thu May 11, 2006 8:12 pm

Re: Nesting / Tool Path

Post by Les Newell »

You can save tool pathed parts in File->save part. You can then load that part at a later date. Note parts don't contain the tool settings so if you change your tool set your operations will be affected.
Pussnboobs
Posts: 9
Joined: Sat Feb 01, 2020 11:44 am

Re: Nesting / Tool Path

Post by Pussnboobs »

Sounds great will give it a go.
Post Reply