Is there a way to reverse cut order?

[tubetorcher]

I am looking for a way to automatically reverse the start order of cuts without having to manually use Quick Cut Sequence.

If not in Sheetcam, is there a way to use post processing to reverse the order?

I ask, because I have several hundred cut files that I also need to have upside down versions of, and my plasma cutter requires that I cut from bottom to top. I can rotate the part 180 degrees, but I would like to not have to resequence all of the cuts

[robertspark]

Mirror / flip one of the axis?

[tubetorcher]

Mirroring X and Y doesn't change the order of cuts on my part.

[Les Newell]

If everything is nested in one drawing edit your cut operation and go to the 'cut path tab'. Set the start position in the opposite side. If you have a number of drawings nested in SheetCam you may also have to definine a tool change position at the opposite end of the sheet.