Switch between different machines

Having problems with or questions about SheetCam? Post them here.
Post Reply
otti
Posts: 2
Joined: Tue Dec 31, 2019 4:57 pm

Switch between different machines

Post by otti »

Hello,

I am operating a milling machine and a plasma table with SheetCAM.

I have created a configuration for both machines and saved this config in a .machine file with the Options-->Machine-->Save/Load diaog.

Is there a possibility to start SheetCAM with an additional command line parameter and the path to a .maschine file to load the milling or the plasma configuration? This would save me a lot of time.

Or is there another way to switch quickly between two or more different machines?



Regards,
Otti
User avatar
Les Newell
Site Admin
Posts: 3661
Joined: Thu May 11, 2006 8:12 pm

Re: Switch between different machines

Post by Les Newell »

otti
Posts: 2
Joined: Tue Dec 31, 2019 4:57 pm

Re: Switch between different machines

Post by otti »

Hi Les,

thanks for your answer. This is exactly what I have seached for.
Post Reply