Error 183:
Posted: Thu Nov 07, 2019 12:08 pm
Sorry if this is an elementary error... I'm very new to the sheetcam program. My husband and I purchased a cnc plasma table in July. We just now got the table and cutter in and are working on assembling it. In the meantime I'm attempting to get projects ready to go to get cutting soon. When we purchased this cnc plasma table it came with inkscape, sheetcam, and one other operating program. Everything downloaded just fine. But when I go into sheetcam I get this error message:
Directory 'C:\...\AppData\Roaming\SheetCamTNG' couldn't be created (error 183: cannot create a file when that file already exists.)
If I click through the error messages I can get into sheetcam but its not set up properly for the table we have. I have gone through the steps to uninstall sheetcam and attempt to reinstall it several times with this same message occurring. I have contacted the gentleman we purchased the cnc plasma table/programs from but he had never seen this error before and was going to do some checking into it (that was over a week ago).
Any ideas? Again sorry if this is something silly to ask. I'm a rookie at sheetcam and still have lots to learn. Thanks for any advice you can give.
-Laren
If I click through the error messages I can get into sheetcam but its not set up properly for the table we have. I have gone through the steps to uninstall sheetcam and attempt to reinstall it several times with this same message occurring. I have contacted the gentleman we purchased the cnc plasma table/programs from but he had never seen this error before and was going to do some checking into it (that was over a week ago).
Any ideas? Again sorry if this is something silly to ask. I'm a rookie at sheetcam and still have lots to learn. Thanks for any advice you can give.
-Laren