Minimum documentation issue.

Having problems with or questions about SheetCam? Post them here.
Post Reply
Jolbas
Posts: 88
Joined: Sat Feb 02, 2019 8:59 am

Minimum documentation issue.

Post by Jolbas »

In the Post documentation:

materialTop
Z coordinate of material top (always 0)

I say this is not true.
When either "material thickness" or "height of bottom of material above table" is set then material top is set to the sum of those (not 0).
Not a big issue but easy to fix.
Jolbas
Posts: 88
Joined: Sat Feb 02, 2019 8:59 am

Re: Minimum documentation issue.

Post by Jolbas »

This is if "Z zero" post processor setting is not set to "Top of work".
Post Reply