Les i think your right on as usual . Ok i figured out what i did wrong... Nothing to see here . Will try testing this as soon as i get time.
Thanks again Les and Fabricator99
Post Processor for Flashcut Version 8
-
- Posts: 6
- Joined: Sat Aug 31, 2019 10:21 pm
Re: Post Processor for Flashcut Version 8
Just trying sheetcam with flashcut have not had time for a bit to play. I am getting a line 6 error opening the gcode. Invalid line parameter. Tried changing the machine name to the same as what i find under ID in flashcut but same error. Let me know if you have seen this or know what might be going on Les. Thank you again.
Josh
Josh