Hey Les,
I tried to search the forum and couldnt find any reference so i just wanted to see if you are aware that the development version 6.1.53 crashes and closes upon attempting to export a part to nestfab. Perhaps i'm doing something wrong.
Also i cannot get sheetcam to import a nestfab file. nestfab uses file extension .nfb and sheetcam expects .nest I havent downloaded mynesting to see if there is an issue with it too.
Thanks
Development version 6.1.53 crash on export to nestfab
-
- Posts: 452
- Joined: Wed Sep 12, 2018 8:18 pm
- Location: South Carolina, USA
- Contact:
- Les Newell
- Site Admin
- Posts: 3660
- Joined: Thu May 11, 2006 8:12 pm
Re: Development version 6.1.53 crash on export to nestfab
Hi David,
I did some tests and it does look like something is pretty broken. I can't get it to crash but Nestfab won't import the files generated by SheetCam. It looks like they have made some changes.
As a workaround you can load your drawings directly into Nestfab, nest them then export the nest as a dxf, which you can load into SheetCam.
I did some tests and it does look like something is pretty broken. I can't get it to crash but Nestfab won't import the files generated by SheetCam. It looks like they have made some changes.
As a workaround you can load your drawings directly into Nestfab, nest them then export the nest as a dxf, which you can load into SheetCam.
-
- Posts: 452
- Joined: Wed Sep 12, 2018 8:18 pm
- Location: South Carolina, USA
- Contact:
Re: Development version 6.1.53 crash on export to nestfab
That's what i ended up doing. I just wanted to make sure you were aware of the glitch. Thanks!