Missing tool table in LinuxCNC
Posted: Fri Aug 09, 2019 9:57 am
Hello,
my LinuxCNC reports an error, because there is no tooltable in the gcode.
How can i solve that problem? (i'm a newbie)
Is there a button in Scam for including the tooltable?
Should i insert something in the EMC postprocessor?
my LinuxCNC reports an error, because there is no tooltable in the gcode.
How can i solve that problem? (i'm a newbie)
Is there a button in Scam for including the tooltable?
Should i insert something in the EMC postprocessor?