Plasma Tool Offsets
Posted: Tue Aug 06, 2019 7:10 pm
It appears the OnOffsetLeft or OnOffsetRight functions only use whatever the offset is of the operation and ignore any offset/direction changes specified to individual start points.
I set up a single operation that has two paths to cut, one inside offset and one outside offset. With the operation cut direction reversed, both should be offset to the left. This is true, and it works. The problem comes when i reverse the cut direction on the inside offset start point only. It should now be a right tool offset, but the post still writes it as a left offset.
I would upload screenshots, but i am not sure how to show what i am talking about. Hopefully this makes sense. Do you have any insight or suggestions?
I set up a single operation that has two paths to cut, one inside offset and one outside offset. With the operation cut direction reversed, both should be offset to the left. This is true, and it works. The problem comes when i reverse the cut direction on the inside offset start point only. It should now be a right tool offset, but the post still writes it as a left offset.
I would upload screenshots, but i am not sure how to show what i am talking about. Hopefully this makes sense. Do you have any insight or suggestions?