.part not saving path rule selections with part

Having problems with or questions about SheetCam? Post them here.
User avatar
Les Newell
Site Admin
Posts: 3661
Joined: Thu May 11, 2006 8:12 pm

Re: .part not saving path rule selections with part

Post by Les Newell »

The next release is due out in the next hour or so. Note that the rule selection was not being saved so your existing part files will still load with no rules selected. You'll have to load the part, select the rules then save it again. Sorry about that.
motoguy
Posts: 121
Joined: Sun May 01, 2016 12:02 am

Re: .part not saving path rule selections with part

Post by motoguy »

Outstanding! Thank you Les! This is a huge timesaver for me!
SeanP
Posts: 217
Joined: Wed Oct 23, 2013 9:50 am

Re: .part not saving path rule selections with part

Post by SeanP »

Thanks Les, good job.
Post Reply