PlasmaRotary Mach3 post problems?
Posted: Sat Jul 06, 2019 8:43 pm
I've been using the Plasma Rotary Mach 3 post for a tube cutter I had built, It was working well until something happened in either mach or sheetcam. I honesty don't know what happened but I can no longer get the tube cutter to work, When I load a TAP file and hit run the rotary spins around forever until it hits the coordinates in line N0100... I found a old TAP file I had of a cut file that i used and worked before I tested it and it works just fine... here is some screen shota of one that works and one that doesn't work I highlighted the code... hopefully someone can help me