Can a Path Rule insert code before M3 ??

Having problems with or questions about SheetCam? Post them here.
Post Reply
mancavedweller
Posts: 161
Joined: Tue Feb 25, 2014 6:53 am

Can a Path Rule insert code before M3 ??

Post by mancavedweller »

Les,

can a Path Rule insert code BEFORE M3. Every time I've used "On Start", or "On Leadin", or "Near Pierce", it puts code AFTER M3.

I know I can put a code snippet before M3 with conditional post processing but in some cases a Path Rule is much more selective and easier/quicker.

This guy reckons his path rule is inserting code before M3. Is that even possible ??
https://www.forum.cncdrive.com/viewtopic.php?f=4&t=2029

Thanks,

Keith
Post Reply