Post Processor Help
Posted: Tue Jun 11, 2019 2:07 am
Hi ive been staring at post processor script for hours the past 2 weeks trying to get a post processor to work for my new planet-cnc controller with no luck, if I edit one post processor to get something to work it will still tend to have another issue.
LinuxCNC post would work if I could get G92 to work to set Z at 0 then go to pierce but cant get G92 added with an error pop up in the controller software.
USB-cnc plasma post ive modified to accept the touch and go probe and works but at the end of each cut they end up on a new plane causeing the machine cooridinates to continue to rise with no reset that will cause an error since everytime the torch finishes a cut moves up 3 inches to rapid z its basically adding 3 inches height each time.
Planet-CNC support says there is a post script for my needs but still have yet to find one.
im really at a lose of what to do.
sheetcam/planet-cnc mk3 controller/ planet-cnc 10.30 software/powermax 45xp ohmic/ proma compact THC/ DIY plasma table
LinuxCNC post would work if I could get G92 to work to set Z at 0 then go to pierce but cant get G92 added with an error pop up in the controller software.
USB-cnc plasma post ive modified to accept the touch and go probe and works but at the end of each cut they end up on a new plane causeing the machine cooridinates to continue to rise with no reset that will cause an error since everytime the torch finishes a cut moves up 3 inches to rapid z its basically adding 3 inches height each time.
Planet-CNC support says there is a post script for my needs but still have yet to find one.
im really at a lose of what to do.
sheetcam/planet-cnc mk3 controller/ planet-cnc 10.30 software/powermax 45xp ohmic/ proma compact THC/ DIY plasma table